Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE ALTITUDE X, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECENTRAL ADAS DECISION MODULE (CADM) - LOW LEVEL - DTCS C00C5-16 TO C2203-00
2024 Jeep Grand Cherokee Altitude X, RWD
Central ADAS Decision Module (CADM) - Low Level - DTCS C00C5-16 To C2203-00
2024 Jeep Grand Cherokee Altitude X, RWDSECTION Central ADAS Decision Module (CADM) - Low Level - DTCS C00C5-16 To C2203-00
- DTC Troubleshooting
- C00C5-16-Rear Radar Module "B" - Circuit Voltage Below Threshold
- C00C5-17-Rear Radar Module "B" - Circuit Voltage Above Threshold
- C00C5-49-Rear Radar Module "B" - Internal Electronic Failure
- C00C5-4A-Rear Radar Module "B" - Incorrect Component Installed
- C00C5-4B-Rear Radar Module "B" - Over Temperature
- C00C5-76-Rear Radar Module "B" - Wrong Mounting Position
- C00C5-86-Rear Radar Module "B" - Signal Invalid
- C00C5-87-Rear Radar Module "B" - Missing Message
- C00C5-97-Rear Radar Module "B" - Component Or System Operation Obstructed Or Blocked
- C00CA-11-Camera "A" Heater Control - Circuit Short To Ground
- C00CA-12-Camera "A" Heater Control - Circuit Short To Battery
- C00CA-13-Camera "A" Heater Control - Circuit Open
- C1240-00-Steering Angle Sensor Angle OVERTRAVEL Performance
- C127A-00-Esp Did Not Respond To Deceleration Request
- C14A3-00-XBW Rule Violation
- C2129-16-Battery Voltage - Circuit Voltage Below Threshold
- C2129-17-Battery Voltage - Circuit Voltage Above Threshold
- C2203-00-Current VIN Missing/Mismatch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.