Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GLADIATOR RUBICON X, FULL TIME T/CASE CONTROL, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMESEATS(OCCUPANT CLASSIFICATION MODULE (OCM) - ELECTRICAL DIAGNOSTICS)
2024 Jeep Gladiator Rubicon X, Full Time T/Case Control, Standard Trans
(Occupant Classification Module (OCM) - Electrical Diagnostics)
2024 Jeep Gladiator Rubicon X, Full Time T/Case Control, Standard TransSECTION (Occupant Classification Module (OCM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B0052-01 Passenger SEATBELT Sensor - General Electrical Failure
- B0061-13 Passenger SEATBELT Tension Sensor - Circuit Open
- B0061-16 Passenger SEATBELT Tension Sensor - Circuit Voltage Below Threshold
- B0061-17 Passenger SEATBELT Tension Sensor - Circuit Voltage Above Threshold
- B0061-2A Passenger SEATBELT Tension Sensor Stuck
- B1B9D-00 Bladder Fluid Level Low
- B1BA8-00 System Out Of Calibration/Not Calibrated
- B1C31-00 Occupant Classification Calibration Range Performance
- B2206-00 Current VIN Missing - Mismatch
- B2212-00 Occupant Classification Module Internal
- B222A-00 Vehicle Line Mismatch
- U0001-00 High Speed Can Communication Bus
- U0002-00 Can C Bus Off Performance
- U0140-00 Lost Communication With Body Control Module
- U0151-00 Lost Communication With Occupant Restraint Controller
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.