Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Theory Of Operation
The Steering Column Control Module (SCCM) is located near the top of the Steering Column underneath the Steering Wheel. The SCCM includes the Clockspring, the Multi-Function Switch and a LIN/CAN C Gateway. LIN Bus messages received by the LIN/CAN C Gateway are broadcast over the CAN C Bus to the appropriate modules.
The Right Hand (RH) Multifunction Switch provides a Front Wiper Washer Switch signal to the Steering Column Control Module (SCCM). The SCCM sends the Front Wiper Washer Switch signal to the Body Control Module (BCM) through the CAN C Bus circuit. When the BCM receives the Front Wiper Washer Switch signal from the SCCM, the BCM activates the Front Wiper Washer Pump.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.