Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GLADIATOR MOJAVE, FULL TIME T/CASE CONTROL, AUTOMATIC TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICES(INTEGRATED CENTER STACK MODULE - ELECTRICAL DIAGNOSTICS)
2024 Jeep Gladiator Mojave, Full Time T/Case Control, Automatic Trans
(Integrated Center Stack Module - Electrical Diagnostics)
2024 Jeep Gladiator Mojave, Full Time T/Case Control, Automatic TransSECTION (Integrated Center Stack Module - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B156E-96 Integrated Center Stack (Ics) - Component Internal Failure
- B157F-2A Button/Knob - Stuck
- B210A-00 System Voltage Low
- B210B-00 System Voltage High
- B210D-00 Battery Voltage Low
- B210E-00 Battery Voltage High
- U0010-00 Can Interior Bus
- U0011-00 Can Interior Bus Off Performance
- U0140-00 Lost Communication With Body Control Module
- U0164-00 Lost Communication With HVAC Control Module
- U0184-00 Lost Communication With Radio
- U0422-00 Implausible Data Received From Body Control Module
- U0424-00 Implausible Data Received From HVAC Control Module
- U0485-00 Implausible Data Received From Radio
- U120E-00 Lost Communication With Comfort Seat And Wheel Module
- U1430-00 Implausible Data Received From Comfort Seat And Wheel Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.