Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023WRANGLER UNLIMITED HIGH TIDELABOR TIMESOTHER VARIANTBRAKESMECHANICAL - HYDRAULICBRAKE SYSTEM (COMPLETE)REMOVE & REPLACE
2023 Jeep Wrangler Unlimited High Tide
Brake System (Complete): Remove & Replace
2023 Jeep Wrangler Unlimited High TideSECTION Remove & Replace
WARNING: This page is about the Wrangler Unlimited High Altitude 4xe, which is a different variant/trim than selected.
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels | 2.6 | B | ||
| Combination Procedure: AXLE OR WHEEL BEARING: Replace: | ||||
| Rear,One Side | DOES NOT include High Voltage Battery shutoff procedure. | 1.3 | B | |
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Rear,One Side | 1.3 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | Includes: R&I Rear Axle Shafts. Includes: Adjust Parking Brake Shoes and Parking Brake Lever. | 2.6 | B | |
| Combination Procedure: WHEEL BEARING: Replace: DOES NOT include alignment (unless noted otherwise). | ||||
| Hub and Bearing,Front,One | DOES NOT include High Voltage Battery shutoff procedure. | 0.5 | B | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.