Diagnostic Test

2023 Jeep Renegade TrailhawkSECTION Diagnostic Test

CHECK FOR AN ACTIVE DTC 

  1. With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
  2. Record the Environmental Data.
  3. With the scan tool, erase DTCs.
  4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
  5. With the scan tool, read BCM DTCs.

    Did the DTC return?

    Yes 

    • Check the Hazard Warning Switch for anything that may cause a sticking condition. If no problems are found, replace the Hazard Warning Switch in accordance with the Service Information.
    • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

    No 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.