Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023RENEGADE TRAILHAWKREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - DTCS B1000-44 TO B1020-15DTC TROUBLESHOOTINGB100B-15-STOP-STOPTURN (EXTERNALCROWN) LIGHT REAR LEFT LED-CIRCUIT SHORT TO BATTERY OR OPENSET CONDITION
2023 Jeep Renegade Trailhawk
Set Condition
2023 Jeep Renegade TrailhawkSECTION Set Condition
- When the Body Control Module (BCM) detects an open or short to voltage on the Left Rear Stop/Turn Signal Feed circuit.
- The system voltage is greater than 9.0 volts and less than 16.0 volts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.