Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA NOTE:
CLEARING THE DTC AFTER A REPAIR - Perform after a wiring repair or component replacement:
To erase the DTC from the Body Control Module (BCM), the BCM must detect an ignition ON/OFF/ON cycle, making sure the Power Accessory Delay (PAD) is deactivated (driver door opened) after the ignition transitions to the OFF position, along with the normal operation of the system that is associated with this DTC.
- Turn the ignition on.
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
- With the scan tool, read Body Control Module (BCM) DTCs.
Is the DTC Active?
Yes
- Go To 2
No
- Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- DISCONNECT THE POWER DISTRIBUTION CENTER (PDC) ASSEMBLY HARNESS CONNECTOR AND CHECK THE (P307) ACCESSORY DELAY 2 RELAY CONTROL CIRCUIT FOR CONTINUITY TO GROUND
- The ignition must be off when checking a circuit for continuity to ground.
- Disconnect the Power Distribution Center (PDC) Assembly harness connector containing the circuit being tested. Note: Use the wiring diagram as a guide to follow the path of the circuit.
- Connect the negative lead of the DVOM to a known good ground.
- Connect the positive lead of the DVOM to the circuit being tested at the PDC Assembly harness connector and check for continuity between the circuit and ground.
NOTE:When probing a circuit at any harness connector, always use an appropriate probing tool to prevent any possible damage to the harness connector terminals.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.