Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE SUMMIT 4XEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECENTRAL ADAS DECISION MODULE (CADM) - LOW LEVEL - DTCS C00C5-97 TO U0155-00DTC TROUBLESHOOTINGC1240-00 STEERING ANGLE SENSOR ANGLE OVERTRAVEL PERFORMANCEPOSSIBLE CAUSES
2023 Jeep Grand Cherokee Summit 4xe
Possible Causes
2023 Jeep Grand Cherokee Summit 4xeSECTION Possible Causes
| Possible Causes |
|---|
| STEERING ANGLE SENSOR DTC SET IN THE ELECTRIC POWER STEERING (EPS) MODULE |
| STEERING ANGLE SENSOR DTC SET IN THE BRAKE SYSTEM CONTROL MODULE (BSCM) |
| ELECTRIC POWER STEERING (EPS) MODULE |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.