Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Long Range Camera Front (LRCF)
| Refer to COMPONENT INDEX . |
Image Acquisition
The LRCF is wired directly to the CADM2 assembly and is used to identify road edges, visible lane markings, and to track lane boundaries. This information is an internal input to the CADM2 for processing.
In the daytime, the LRCF will detect lane marking where lighting and environmental conditions provide good visibility in excess of 30 meters.
At night, the LRCF will detect the lane markings with lighting conditions provided by standard, productions low beam headlamps, with or without additional sources of road illumination, and where environmental conditions provide good visibility in excess of 30 meters.
The LRCF is able to compensate for sudden changes in lighting conditions such as during tunnel entry or exist.
The CADM2 implements data integrity and plausibility checks for the video data over Low Voltage Differential Signaling (LVDS).
Field of View
The effective horizontal field of view of the LRCF is a minimum of 36 degrees.
The effective vertical field of view of the LRCF is a minimum of 20 degrees.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.