Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE LIMITED, RWDLABOR TIMESOTHER VARIANTBRAKESMECHANICAL - HYDRAULICCALIPERREMOVE, INSTALL, AND OVERHAUL
2023 Jeep Grand Cherokee Limited, RWD
Mechanical - Hydraulic: Caliper: Remove, Install, and Overhaul
2023 Jeep Grand Cherokee Limited, RWDSECTION Remove, Install, and Overhaul
WARNING: This page is about the Grand Cherokee 30th Anniversary 4xe, which is a different variant/trim than selected.
Includes: Bleed Brake System and replace Pads (if necessary).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,Dual Piston Calipers,Both | 2.2 | B | ||
| Front,Dual Piston Calipers,One Side | 1.2 | B | ||
| Rear,Single Piston Calipers,Both | 1.8 | B | ||
| Rear,Single Piston Calipers,One Side | 1.0 | B | ||
| Combination Procedure: 12 VOLT BATTERY SHUTOFF PROCEDURE: Perform: | ||||
| 2.0L Eng,Gas/Electric | Includes: Disable and Enable High Voltage System. | 1.3 | C | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | 0.2 | B | ||
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Maintenance Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.