Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE LAREDO X, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (2 OF 3)MODULE, ELECTRONIC STEERING LOCK (ESL)
2023 Jeep Grand Cherokee Laredo X, AWD
Module, Electronic Steering Lock (ESL)
2023 Jeep Grand Cherokee Laredo X, AWDSECTION Module, Electronic Steering Lock (ESL)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1A92-11 | STEERING LOCK MOTOR - CIRCUIT SHORT TO GROUND |
| B1A92-12 | STEERING LOCK MOTOR - CIRCUIT SHORT TO BATTERY |
| B1A92-13 | STEERING LOCK MOTOR - CIRCUIT OPEN |
| B1A92-71 | STEERING LOCK MOTOR - ACTUATOR STUCK |
| B1A93-64 | STEERING LOCK MOTOR SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| B2100-64 | IGNITION RUN/START INPUT - SIGNAL PLAUSIBILITY FAILURE |
| B2199-16 | BATTERY VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD |
| B2199-17 | BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B22A9-01 | ECU INTERNAL PERFORMANCE - GENERAL ELECTRICAL FAILURE |
| U0002-00 | CAN C BUS OFF PERFORMANCE |
| U1056-00 | HIGH SPEED FD-CAN 3 COMMUNICATION BUS |
| U1110-00 | LOST VEHICLE SPEED MESSAGE |
| U1175-00 | LOST IGNITION STATUS MESSAGE |
| U11D0-00 | LOST IGNITION KEY STATUS MESSAGE |
| U1220-00 | LOST STEERING LOCK REQUEST MESSAGE |
| U1412-62 | IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED - SIGNAL COMPARE FAILURE |
| U1412-64 | IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED - SIGNAL PLAUSIBILITY FAILURE |
| U1433-62 | IMPLAUSIBLE IGNITION SWITCH STATUS MESSAGE RECEIVED - SIGNAL COMPARE FAILURE |
| U1433-64 | IMPLAUSIBLE IGNITION SWITCH STATUS MESSAGE RECEIVED - SIGNAL PLAUSIBILITY FAILURE |
| U148F-64 | IMPLAUSIBLE VEHICLE SPEED MESSAGE RECEIVED - SIGNAL PLAUSIBILITY FAILURE |
| U1517-62 | BODY CONTROLLER SECRET CODE - SIGNAL COMPARE FAILURE |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.