Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Night Vision Processing Module
Calibration is needed when any of the following occur:
- Night Vision Camera (NVC) replacement
- Night Vision Processing Module (NVPM) replacement
- System needs calibration due to relevant Diagnostic Trouble Codes (DTCs) or relevant customer concerns to the Night Vision system
The routine requires the NVPM heated plate target. This is a component of the (special tool #2076800080, ADAS Calibration System)
Using the diagnostic scan tool, navigate to the NVPM's "Misc. Functions" menu. Select and perform the following routine: "NVPM camera pairing and alignment calibration"
Follow the on-screen prompts to complete the calibration/programming.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.