Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE LAREDO X, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECENTRAL ADAS DECISION MODULE (CADM) - LOW LEVEL - DTCS C00C5-97 TO U0155-00
2023 Jeep Grand Cherokee Laredo X, AWD
Central ADAS Decision Module (CADM) - Low Level - DTCS C00C5-97 To U0155-00
2023 Jeep Grand Cherokee Laredo X, AWDSECTION Central ADAS Decision Module (CADM) - Low Level - DTCS C00C5-97 To U0155-00
- DTC Troubleshooting
- C00C5-97 Rear Radar Module "B" - Component Or System Operation Obstructed Or Blocked
- C00CA-11 Camera "A" Heater Control - Circuit Short To Ground
- C00CA-12 Camera "A" Heater Control - Circuit Short To Battery
- C00CA-13 Camera "A" Heater Control - Circuit Open
- C1240-00 Steering Angle Sensor Angle OVERTRAVEL Performance
- C127A-00 Esp Did Not Respond To Deceleration Request
- C14A3-00 XBW Rule Violation
- C2129-16 Battery Voltage - Circuit Voltage Below Threshold
- C2129-17 Battery Voltage - Circuit Voltage Above Threshold
- C2203-00 Current VIN Missing/Mismatch
- C2210-00 Ecu Over Temperature
- C2212-00 Ecu In-Plant Mode
- C2225-00 Pcm Disabled Ecu
- C2226-00 TCM Disabled Ecu
- C2227-000 Abs Disabled Ecu
- C2318-49 Front Camera - Internal Electronic Failure
- C2318-4B Front Camera - Over Temperature
- C2318-54 Front Camera - Missing Calibration
- C2318-76 Front Camera - Wrong Mounting Position
- C2318-97 Front Camera - Component Or System Operation Obstructed Or Blocked
- P0602-00 Control Module Programming Error/Not Programmed
- P1593-2A Speed Control Switch 1/2 - Stuck
- U0100-00 Lost Communication With ECM/Pcm "A"
- U0101-00 Lost Communication With TCM
- U011D-00 Lost Communication With All Wheel Drive Control Module
- U0129-00 Lost Communication With Brake System Control Module 1
- U0131-00 Lost Communication With Power Steering Control Module "A"
- U0140-00 Lost Communication With Body Control Module
- U0149-00 Lost Communication With Security Gateway
- U0151-00 Lost Communication With Occupant Restraint Controller (Orc)
- U0155-00 Lost Communication With Cluster/CCN
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.