Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE L LAREDO, AWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANS8HP50/850RE AUTOMATIC TRANSMISSION - DTCS P0219-00 TO P07B4-00DTC TROUBLESHOOTINGP061B-00-INTERNAL CONTROL MODULE TORQUE CALCULATION PERFORMANCESET CONDITION
2023 Jeep Grand Cherokee L Laredo, AWD
Set Condition
2023 Jeep Grand Cherokee L Laredo, AWDSECTION Set Condition
Condition One:
- Positive engine torque is transmitted when no positive torque is commanded by the Transmission Control Module (TCM).
- The difference of the transmitted engine torque and the requested engine torque is greater than a calibrated threshold.
Condition Two:
- Actual engine torque request and the delivered engine torque request sent via BUS is greater than a calibrated threshold.
Condition Three:
- A positive engine torque request is sent via BUS and no positive torque request was calculated by the TCM.
Condition Four:
- The engine torque for the calculated gear is less than a calibrated threshold.
Condition Five:
- The difference between the actual engine torque and the requested negative engine torque is greater than a calibrated threshold.
Condition Six:
- A negative engine torque request is sent via BUS and no negative torque request was calculated by the TCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.