Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GRAND CHEROKEE L LAREDO, AWDREPAIR AND DIAGNOSISRESTRAINTSSEAT BELTSOCCUPANT RESTRAINT CONTROLLER (ORC) - DTCS B007F-13 TO B00B5-13DTC TROUBLESHOOTINGB0080-13-DRIVER SEATBELT LOAD LIMITER DEPLOYMENT CONTROL-CIRCUIT OPENDIAGNOSTIC TEST
2023 Jeep Grand Cherokee L Laredo, AWD
Diagnostic Test
2023 Jeep Grand Cherokee L Laredo, AWDSECTION Diagnostic Test
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
- With the scan tool, read ORC DTCs and record on the repair order.
- With the scan tool, run a Vehicle Scan Report or record the Environmental Data.
- With the scan tool, erase DTCs.
- Turn the ignition off for at least 10.0 seconds.
- Turn the ignition on.
- Using the recorded Environmental Data and the When Monitored Conditions, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read ORC DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- CHECK THE RELATED CONNECTORS AT THE CONTROLLER AND THE SUSPECT DEVICE WARNING:
Turn the ignition off, disconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.