Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Inverter Module
REMOVAL
- Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT, 3.0L and/or BATTERY DISCONNECT, 3.6L .
- Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
- Remove the Comfort Seat and Wheel Module (CSWM), if equipped. Refer to MODULE, COMFORT SEAT AND WHEEL (CSWM), REMOVAL AND INSTALLATION
.
1 - Bolt 2 - Mounting Bolt 3 - Mounting Bolt 4 - Power Inverter Module - Remove the two upper power inverter module bracket to Instrument Panel (IP) support mounting bolts.
- Remove the two lower power inverter module bracket to IP support mounting bolts.
- Carefully remove the bracket with the power inverter module and disconnect the wire harness connector.
1 - Bracket Bolt 2 - Power Inverter Module - Remove the three power inverter to bracket bolts and separate the power inverter module from the bracket.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Tighten the bolts securely to the proper specification.
Refer to TECHNICAL SPECIFICATIONS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.