Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GLADIATOR FREEDOM, FULL TIME T/CASE CONTROLREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASEDRIVETRAIN CONTROL MODULE (DTCM) - DTCS C1477-4B TO U0429-00
2023 Jeep Gladiator Freedom, Full Time T/Case Control
Drivetrain Control Module (DTCM) - DTCS C1477-4B To U0429-00
2023 Jeep Gladiator Freedom, Full Time T/Case ControlSECTION Drivetrain Control Module (DTCM) - DTCS C1477-4B To U0429-00
- DTC Troubleshooting
- C1477-4B-Transfer Case Clutch-Over Temperature
- C147B-12-Front Axle Disconnect Sensor-Circuit Short To Battery
- C147B-14-Front Axle Disconnect Sensor-Circuit Short To Ground Or Open
- C147B-92-Front Axle Disconnect Sensor-Performance Or Incorrect Operation
- C147E-11-Front Axle Disconnect Power Supply-Circuit Short To Ground
- C147E-12-Front Axle Disconnect Power Supply-Circuit Short To Battery
- C149D-00-Clutch Calibration Not Learned
- C149E-11-Transfer Case Motor Position Sensor-Circuit Short To Ground
- C149E-12-Transfer Case Motor Position Sensor-Circuit Short To Battery
- C149E-13-Transfer Case Motor Position Sensor-Circuit Open
- C149E-64-Transfer Case Motor Position Sensor-Signal Plausibility Failure
- C149E-94-Transfer Case Motor Position Sensor-Unexpected Operation
- C14AA-11-Transfer Case Motor Position Sensor Supply-Circuit Short To Ground
- C14AA-12-Transfer Case Motor Position Sensor Supply-Circuit Short To Battery
- C14AA-13-Transfer Case Motor Position Sensor Supply-Circuit Open
- C2129-16-Battery Voltage - Circuit Voltage Below Threshold
- C2129-17-Battery Voltage - Circuit Voltage Above Threshold
- C2201-00-FDCM-DTCM Internal
- C2206-00-Vehicle Configuration Mismatch
- U0001-00-Can C Bus
- U0100-00-Lost Communication With ECM/Pcm
- U0101-00-Lost Communication With TCM
- U0121-00-Lost Communication With Anti-Lock Brake System (Abs) Control Module
- U0140-00-Lost Communication With Body Control Module
- U0212-00-Lost Communication With Steering Column Control Module
- U0401-00-Implausible Data Received From ECM/Pcm
- U0402-00-Invalid Data Received From TCM
- U0415-00-Implausible Data Received From Abs
- U0422-00-Implausible Data Received From Body Control Module
- U0429-00-Implausible Data Received From SCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.