Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GLADIATOR FREEDOM, FULL TIME T/CASE CONTROLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - DTCS B18CF-15 TO B2303-11
2023 Jeep Gladiator Freedom, Full Time T/Case Control
Body Control Module (BCM) - DTCS B18CF-15 To B2303-11
2023 Jeep Gladiator Freedom, Full Time T/Case ControlSECTION Body Control Module (BCM) - DTCS B18CF-15 To B2303-11
- DTC Troubleshooting
- B18CF-15-Secondary Driver Door Ajar-Circuit Short To Battery Or Open
- B1E01-11-Mirror Power Supply-Circuit Short To Ground
- B1E01-15-Mirror Power Supply-Circuit Short To Battery Or Open
- B1E72-11 - Power Inverter Enable Control-Circuit Short To Ground-110V
- B2103-11-Ignition Run/Start 1 Control-Circuit Short To Ground
- B2103-15-Ignition Run/Start 1 Control-Circuit Short To Battery Or Open
- B2119-11-Ignition Run/Acc/SPAD Control-Circuit Short To Ground
- B2119-15-Ignition Run/Acc/SPAD Control-Circuit Short To Battery Or Open
- B2121-11-Ignition Run Control 1-Circuit Short To Ground
- B2121-15-Ignition Run Control 1-Circuit Short To Battery Or Open
- B212E-11-Ignition Run/Acc Control-Circuit Short To Ground
- B212E-15-Ignition Run/Acc Control-Circuit Short To Battery Or Open
- B2143-11-UGDO Enable Control-Circuit Short To Ground
- B2183-11-Ignition Unlock Run-Start Control-Circuit Short To Ground
- B2193-00-Intelligent Battery Sensor Internal
- B2199-16-Battery Voltage-Circuit Voltage Below Threshold
- B2199-17-Battery Voltage-Circuit Voltage Above Threshold
- B21F8-13-Exterior Lighting Power Supply Input 1-Circuit Open
- B21F9-13-Exterior Lighting Power Supply Input 2-Circuit Open
- B2204-4A-Ecu Configuration Mismatch-Incorrect Component Installed
- B2204-56-Ecu Configuration Mismatch-Invalid-Incompatible Configuration
- B2206-00-Current VIN Missing/Mismatch
- B222C-00-Vehicle Configuration Not Programmed
- B225C-00-Compass Module Internal
- B2267-00-Interior Rear View Mirror Module Internal
- B2303-11-Wiper Park Switch Input-Circuit Short To Ground
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.