Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LIMITEDREPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEM (ABS) (ZF TRW) - DTCS C1304-86 TO C1438-86
2023 Jeep Compass Limited
Antilock Brake System (Abs) (ZF TRW) - DTCS C1304-86 To C1438-86
2023 Jeep Compass LimitedSECTION Antilock Brake System (Abs) (ZF TRW) - DTCS C1304-86 To C1438-86
- DTC Troubleshooting
- C1304-86-Tire Pressure Module System (TPMS) Calibration Incomplete - Signal Invalid
- C1307-64-Tire Pressure Module System Low Availability - Signal Plausibility Failure
- C130A-64-Tire Pressure Module System - Fail Front Left Wheel - Signal Plausibility Failure
- C130B-64-Tire Pressure Module System - Fail Front Right Wheel - Signal Plausibility Failure
- C130C-64-Tire Pressure Module System - Fail Rear Left Wheel - Signal Plausibility Failure
- C130D-64-Tire Pressure Module System - Fail Rear Right Wheel - Signal Plausibility Failure
- C1400-01-Electric Park Brake Switch - General Electrical Failure
- C1400-13-Electric Park Brake Switch - Circuit Open
- C1400-97-Electric Park Brake Switch - Component Or System Operation Obstructed Or Blocked
- C1403-01-Electric Park Brake Motor Right - General Electrical Failure
- C1403-11-Electric Park Brake Motor Right - Circuit Short To Ground
- C1403-13-Electric Park Brake Motor Right - Circuit Open
- C1403-15-Electric Park Brake Motor Right - Circuit Short To Battery Or Open
- C1405-01-Electric Park Brake Motor Left - General Electrical Failure
- C1405-11-Electric Park Brake Motor Left - Circuit Short To Ground
- C1405-13-Electric Park Brake Motor Left - Circuit Open
- C1405-15-Electric Park Brake Motor Left - Circuit Short To Battery Or Open
- C1406-86-Electric Park Brake Signal Fault - Signal Invalid
- C1407-19-Electric Park Brake Request Actuation Fault Motor Right - Circuit Current Above Threshold
- C1407-77-Electric Park Brake Request Actuation Fault Motor Right - Commanded Position Not Reachable
- C1408-19-Electric Park Brake Request Actuation Fault Motor Left - Circuit Current Above Threshold
- C1408-77-Electric Park Brake Request Actuation Fault Motor Left - Commanded Position Not Reachable
- C1409-07-Mechanical Fault Right EPB Actuator - Mechanical Failures
- C140A-07-Mechanical Fault Left EPB Actuator - Mechanical Failures
- C140B-94-Incoherent State Of EPB - Unexpected Operation
- C140C-04-Electric Park Brake Software Incompatible - System Internal Failure
- C140D-54-Assembly Check Not Performed - Missing Calibration
- C140E-53-Electric Park Brake In Maintenance Mode - Deactivated
- C140F-53-Electric Park Brake Automatic Functions - Deactivated
- C1416-87-VIN Message - Missing Message
- C1420-64-DASM Implausibility Request - Signal Plausibility Failure
- C1421-67-DASM Request During Fail - Signal Incorrect After Event
- C1422-64-Time Long Duration Request From DASM - Signal Plausibility Failure
- C1423-86-Deceleration Request From DASM Out Of Range - Signal Invalid
- C1424-64-Standstill Request From DASM - Signal Plausibility Failure
- C1425-01-Led Switch EPB Fault - General Electrical Failure
- C1426-86-Engine Status Valid Data - Signal Invalid
- C1427-87-Orc Yrs Data Message (From Occupant Restraint Controller) - Missing Message
- C1429-86-Seat Belt Information Failure - Signal Invalid
- C1430-87-Airbag 2 Message (From Occupant Restraint Controller) - Missing Message
- C1431-86-Signal Not Valid From TRANSM3 Message - Signal Invalid
- C1432-87-TRANSM 2 Message (From Dual Clutch Transmission Module) - Missing Message
- C1433-86-ADAPTATIVE Cruise Control Fail Status Signals - Signal Invalid
- C1434-86-Cross Check Acceleration Or Deceleration Request From Adaptive Cruise Control System - Invalid Signal
- C1435-86-Cross Check Signals Not Available For Adaptive Cruise Control - Invalid Signal
- C1437-86-Cross Check Longitudinal Acceleration Signal From Orc (Occupant Restraint Control) No Valid For Acc Function - Invalid Signal
- C1438-86-Cross Check External Light Signal Not Valid For Adaptive Cruise Control Function - Invalid Signal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.