SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LATITUDEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - COMMUNICATION DIAGNOSTIC PROCEDURE AND BODY VERIFICATION TESTSTANDARD PROCEDUREBODY VERIFICATION TEST
2023 Jeep Compass Latitude

Body Verification Test

2023 Jeep Compass LatitudeSECTION Body Verification Test

Perform the  BODY VERIFICATION TEST  

  1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
  2. Make sure all accessories are turned off.
  3. Make sure the battery is fully charged.
  4. Turn the ignition on.
  5. With the scan tool, record and erase Diagnostic Trouble Codes (DTC) s from all modules.
  6. If an electronic control module was replaced, select the applicable module from the scan tool. If the module has programmable features, program as necessary.
  7. Turn the ignition off, wait 10 seconds, and then turn the ignition on.
  8. Operate all functions of the system that caused the original concern. If a repair was done to the power windows, operate the motor fully down and stall it for two seconds, and then to the full up position and stall it for two seconds.
  9. With the scan tool, view all the modules and check for DTCs.

Are DTCs present in any of the modules or is the original condition still present?

Yes 

  • The repair is not complete. Refer to the appropriate procedure or related service information for the DTC or symptom that is still present.

No 

  • The repair is complete.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.