Connector Terminal Removal

2023 Jeep Compass Latitude LuxSECTION Connector Terminal Removal
GC0137482Courtesy of CHRYSLER GROUP, LLC
1 - DRESS COVER
2 - CONNECTOR LOCK
3 - CONNECTOR
  1. Disconnect the battery.
  2. Release the Connector Lock (2).
  3. Disconnect the connector (3) being repaired from its mating half/component.
  4. Remove the dress cover (if applicable) (1).
    GC0137483Courtesy of CHRYSLER GROUP, LLC
    1 - Secondary Terminal Lock
  5. Release the Secondary Terminal Lock, if required (1).
    GC0137484Courtesy of CHRYSLER GROUP, LLC
    1 - TYPICAL CONNECTOR
    2 - PICK FROM TERMINAL REMOVER KIT 10300
    3 - APEX CONNECTOR
    4 - PICK FROM TERMINAL REMOVER KIT 10300
    5 - AUGAT CONNECTOR
    6 - ELECTRICAL TERMINAL REMOVAL TOOL
    7 - MOLEX CONNECTOR
    8 - PICK FROM TERMINAL REMOVER KIT 10300
    9 - THOMAS AND BETTS CONNECTOR
    10 - TERMINAL REMOVER
    11 - CONNECTOR
    12 - ELECTRICAL TERMINAL REMOVER
  6. Position the connector locking finger away from the terminal using the proper special tool. Pull on the wire to remove the terminal from the connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.