Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS HIGH ALTITUDEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADAS(DIGITAL TV MODULE - ELECTRICAL DIAGNOSTICS)
2023 Jeep Compass High Altitude
(Digital TV Module - Electrical Diagnostics)
2023 Jeep Compass High AltitudeSECTION (Digital TV Module - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B1499-11 - TV Antenna 1-Circuit Short To Ground
- B1499-12 - TV Antenna 1-Circuit Short To Battery
- B1499-13 - TV Antenna 1-Circuit Open
- B149B-11 - TV Antenna 2-Circuit Short To Ground
- B149B-12 - TV Antenna 2-Circuit Short To Battery
- B149B-13 - TV Antenna 2-Circuit Open
- B1550-4B - Digital Television Module-Over Temperature
- B2199-16 - Battery Voltage-Circuit Voltage Below Threshold
- B2199-17 - Battery Voltage-Circuit Voltage Above Threshold
- B21DD-84 - System Voltage-Signal Below Allowable Range
- B21DD-85 - System Voltage-Signal Above Allowable Range
- B2206-00-Current VIN Missing / Mismatch
- B222C-00-Vehicle Configuration Not Programmed
- B22A9-00 - Ecu Internal Performance
- B23C4-31 - Side Camera-No Signal
- B23C5-31 - Front Camera-No Signal
- U0010-00-Can Interior Bus
- U0011-00-Can Interior Bus Off Performance
- U0140-00-Lost Communication With Body Control Module
- U0184-00-Lost Communication With Radio
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.