Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023CHEROKEE ALTITUDE LUXREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWARNING SYSTEMSCHIME/BUZZER/DRIVER ASSIST (SERVICE INFORMATION)MODULE, PARK ASSISTREMOVAL
2023 Jeep Cherokee Altitude LUX
Module, Park Assist: Removal
2023 Jeep Cherokee Altitude LUXSECTION Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the quarter trim panel from the left quarter inner panel (1). Refer to PANEL, QUARTER TRIM, REMOVAL .
- Disconnect the wire harness connectors (4) from the Park Assist Module (PAM) (3) connector receptacles on the left quarter inner panel just behind the left rear wheel house.
- Remove the fasteners (2) that secure the PAM to the weld studs on the quarter inner panel.
- Remove the PAM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.