Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Torque Specifications
2023 Jeep Cherokee Altitude LUXSECTION Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Active Noise Cancellation Bracket to I/P Carrier | 7 | - | 62 | |
| Amplifier Bracket to I/P Carrier | 7 | - | 62 | |
| Heating, Ventilation and Air Conditioning (HVAC) Module to HVAC Housing Screw | 2 | - | 17 | |
| Antilock Brake Module to Hydraulic Control Unit Screws | 2 | - | 17 | |
| Body Control Module (BCM) to Mounting Bracket Screw | 5 | - | 44 | |
| BCM Mounting Bracket to Instrument Panel Support Structure Screw | 6 | - | 53 | |
| DriveTrain Control Module Nut | 7 | - | 62 | |
| Electric Park Brake Nut | 7 | - | 62 | |
| Electronic Steering Lock (ESL) Module Bolt | 15 | 11 | - | |
| Powertrain Control Module (PCM) to Bracket Nut | 7 | - | 62 | |
| PCM Bracket to Bulkhead Nut | 6 | 53 | ||
| PCM Ground Wire Install | 7 | - | 62 | |
| PCM Ground Wire Nut | 7 | - | 62 | |
| Security Gateway Module (SGW) Bolt | 4 | - | 35 | |
| Steering Column Control Module (SCCM) Band Clamp Screw | 7 | - | 62 | |
| Transmission Control Module (TCM) to Case Bolt | 20 | 15 | - | |
| Tunnel Ground Nut | 8 | - | 71 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.