Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023CHEROKEE ALTITUDE LUXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER LOCKS (SERVICE INFORMATION)ANTENNA, PASSIVE ENTRYREMOVALCENTER FLOOR CONSOLE
2023 Jeep Cherokee Altitude LUX
Center Floor Console
2023 Jeep Cherokee Altitude LUXSECTION Center Floor Console
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the center floor console from the vehicle. Refer to CONSOLE, FLOOR, REMOVAL .
- Disconnect the wire harness connector from the connector receptacle for the Low Frequency (LF) antenna (1) beneath the front of the console.
- Remove the fasteners that secure the antenna to the bracket beneath the front of the console.
- Remove the antenna from the console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.