2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE

Relay, Power Control: Installation

GC0175256Courtesy of CHRYSLER GROUP, LLC
  1. Using two nuts, install the Power Control Relay (2) to the PCR bracket (1) and tighten them to the proper specifications. Refer to TORQUE SPECIFICATIONS .
    GC0175214Courtesy of CHRYSLER GROUP, LLC
  2. Connect and secure the eyelet terminals (1) to the PCR and tighten the nuts (3) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
  3. Connect the wire harness connector (2) to the PCR.
    GC0175247Courtesy of CHRYSLER GROUP, LLC
  4. Install the PCR cover (1) to the PCR.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.