Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| AUX Battery M6 Nut to Positive Cable | 6 | - | 53 |
| AUX Battery M6 Nut to Negative Cable | 6 | - | 53 |
| AUX Battery positive post - M6 Double ended Torx Stud | 6 | - | 53 |
| AUX Battery negative post - M6 Double ended Torx Stud | 6 | - | 53 |
| Battery Positive to Jump Start Post | 10 | 7 | - |
| Battery Positive Cable to Terminal End | 9 | - | 80 |
| Negative Battery Jump Post to Body | 10 | 7 | - |
| Negative Battery Cable to IBS | 11 | 8 | - |
| IBS to Negative Battery Terminal Post | 6 | - | 53 |
| Starter Solenoid B(+) Terminal Stud Nut | 17 | - | 150 |
| Battery Negative Cable Ground Eyelet Terminal to Engine Block Bolt | 11 | 8 | - |
| Battery Hold Down Bracket to Body Nut | 20 | 15 | - |
| Battery Strap to Tray Nut | 8 | - | 71 |
| Generator Output Terminal Stud Nut | 17 | - | 150 |
| Power Distribution Center B(+) Terminal Stud Nut | 25 | 18 | - |
| Integrated Power Module B(+) Terminal Stud Nut | 11 | 8 | - |
| Integrated Power Module B(-) to Terminal Stud | 6 | - | 53 |
| Negative Cable to Integrated Power Module | 11 | 8 | - |
| Battery Negative Cable Eyelet Terminal to Floor Pan | 14 | 10 | - |
| B+ Wire to PCR Relay | 11 | 8 | - |
| PCR Relay Mount to Shock Tower | 11 | 8 | - |
| Ground Wire Mounting Nut | 24 | 18 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
