2021 Jeep Cherokee High Altitude, Automatic T/Case ControlFACTORY OEM SERVICE PROCEDURE

Sensor, Coolant Temperature: Installation

GC0186450Courtesy of CHRYSLER GROUP, LLC
  1. Install the engine coolant temperature sensor (1) and tighten to the proper torque specification. Refer to (TORQUE SPECIFICATIONSΒ ).
    GC0186474Courtesy of CHRYSLER GROUP, LLC
  2. Connect the engine coolant temperature sensor harness connector (1).
  3. Fill the cooling system. Refer to COOLANT SYSTEM AIR EVACUATIONΒ  .
  4. Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.