2021 Jeep Cherokee High Altitude, Automatic T/Case ControlFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

DESCRIPTION N.m Ft. Lbs. In. Lbs. COMMENT
Belt Tensioner M10 Bolt 50 37 -  
Coolant Tube Screw 10 - 89  
Engine Coolant Temperature Sensor 30 22 -  
Idler Pulley M8 Bolt 25 18 -  
Pressurized Coolant Bottle Bolts 6 - 53  
Thermostat Housing Screws 10 - 89  
Thermostat Coolant Manifold Bolts 11 8 -  
Transmission Oil Heater Tube Assembly 10 - 89  
Water Pump M8 Bolts 25 18 -  
Water Pump M8 Stud Bolt 25 18 -  
Water Pump Inlet Tube Bolts 11 8 -  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.