Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Cherokee High Altitude, Automatic T/Case ControlFACTORY OEM SERVICE PROCEDURE
Fan, Cooling: Installation
- Install the cooling fan (2) to the radiator and securely tighten the bolts (1).
- Install the upper radiator hose.
- Install the right and left air deflectors and fasteners.
- Install the upper core support (3) and tighten the six bolts (1, 2) to the proper torque specification. Refer to (TORQUE SPECIFICATIONS ).
- Install the upper radiator panel (2). Install and securely tighten the fasteners (1).
- Connect the ambient air temperature sensor wire harness connector (1).
- Install the wiring harness (1) and the wire harness retainers to the upper radiator panel (2).
- Connect the cooling fan module wiring harness connector.
- Attach the coolant hose (1) to the upper radiator panel (2).
- Install the turbocharger heat shield nut and stud (1) and tighten to the proper torque specification. Refer to (TORQUE SPECIFICATIONS ).
- Install the catalytic converter heat shield (2) and tighten the bolts (1) to the proper torque specification. Refer to (TORQUE SPECIFICATIONS ).
- Connect the upper oxygen sensor wire harness connector.
- Install the hood latch. Refer to LATCH, HOOD, INSTALLATION .
- Install the pressurized coolant bottle. Refer to INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
