SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING LINKAGESTEERING SYSTEMPUMPREMOVAL3.0L DIESEL
2014 Jeep Grand Cherokee Laredo, AWD

3.0L Diesel

2014 Jeep Grand Cherokee Laredo, AWDSECTION 3.0L Diesel
Fig 1: EHPS Pump, Pump Pressure & Supply/Return Line Assembly
GC0145802Courtesy of CHRYSLER GROUP, LLC
  1. Siphon the power steering reservoir.
  2. Disconnect and isolate the battery negative cable. Refer to CABLES, BATTERY, REMOVAL .
  3. Disconnect the two EHPS pump electrical connectors and the wiring harness to bracket routing clip.
  4. Disconnect the supply and return lines from the EHPS pump.
  5. Remove the pressure and return line routing clip bolt from the pump bracket.
  6. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  7. If equipped, remove the front skid plate. Refer to PLATE, SKID, FRONT, REMOVAL .
  8. Remove the pressure line retaining bolt and line from the EHPS pump.
  9. Loosen the routing clip retaining bolt and position the pressure line aside for access to remove the pump.
  10. Remove the three EHPS pump retaining bolts and remove the pump from the vehicle.
  11. Remove and transfer any necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.