Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING LINKAGESTEERING SYSTEMDIAGNOSIS AND TESTINGSTEERING SYSTEM DIAGNOSIS CHARTSFLUID ISSUES
2014 Jeep Grand Cherokee Laredo, AWD
Fluid Issues
2014 Jeep Grand Cherokee Laredo, AWDSECTION Fluid Issues
| CONDITION | POSSIBLE CAUSES | EVALUATION/CORRECTION |
|---|---|---|
| LOW FLUID LEVEL WITH VISIBLE LEAK. | 1. Loose power steering hose fittings or connections. | 1. Check torque on all tube nuts (at gear and pump). Inspect clamps at all rubber hose connections for correct position, damage and tension. Tighten tube nuts as required. Reposition or replace clamps at hose connections. Clean joints and reinspect for leaks. |
| 2. Damaged or missing O-ring at power steering hose tube nuts. | 2. Remove tube nut and inspect O-ring. If damaged or missing, replace O-ring. Clean joints and reinspect for leaks. | |
| 3. Power steering line or hose failure. | 3. Clean fluid from around suspect areas. Run vehicle and inspect for leaks. Look inside reservoir to see if air is being ingested. Replace hoses as necessary. | |
| 4. Power steering component leaking (reservoir, pump, gear). | 4. Clean fluid from around suspect areas. Run vehicle and inspect for leaks. Look inside reservoir to see if air is being ingested. Replace power steering component as necessary. | |
| AERATED FLUID.* | 1. Low power steering fluid level. | 1. Check fluid level and fill to proper level as necessary. Check for leaks. Make sure all air is bled from system. |
| 2. Air leak at power steering supply hose, reservoir or pump. | 2. Inspect components. Put a hand vacuum pump on the reservoir and verify that the system can keep a vacuum. System should not lose more than 1 psi in 2 minutes (make sure vacuum pump is sealed well to the reservoir). | |
| 3. Air leak at power steering supply hose, reservoir or pump. | 3. Inspect components. Place a hand vacuum pump with Adapter 9688 on reservoir and verify that system can sustain vacuum. System should not lose more than 1 psi in 2 minutes (make sure vacuum pump is sealed well to the reservoir). Replace steering component as necessary. | |
| RESERVOIR FLUID OVERFLOW OR FLUID THAT IS MILKY IN COLOR | 1. Water contamination of power steering fluid. | 1. Inspect fluid for milky appearance. Completely drain power steering fluid. Refill and bleed system. Refer to STANDARD PROCEDURE . |
NOTE:
Extremely cold temperatures may cause power steering fluid aeration. The air should work its way out of the system as the fluid warms.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.