Diagnostic Test

2014 Jeep Grand Cherokee Laredo, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.

CHECK FOR ACTIVE DTC 

  1. Turn the ignition ON.
  2. With the scan tool, read the active DTCs.

    Does the scan tool display: DTC U1175-00?

    Yes 

    • Refer to DIAGNOSIS AND TESTING and perform the NO RESPONSE FROM TCM (TRANSMISSION CONTROL MODULE) - 8HP70 diagnostic procedure.

    No 

    • Test complete, the condition or conditions that set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension at the ESM and TCM.
    • Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.