Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (MP3010 TRANSFER CASE (SERVICE INFORMATION))SENSOR, MODEREMOVALREMOVAL

2014 Jeep Grand Cherokee Laredo, AWD

Sensor, Mode: Removal: Removal

2014 Jeep Grand Cherokee Laredo, AWDSECTION Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Encoder & Transfer Case

Courtesy of CHRYSLER GROUP, LLC

Remove the wiring harness electrical connector from the encoder.
Remove the screws securing the encoder to the rear transfer case housing.
Remove the encoder from the transfer case.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.