Section 6 (Mp3010 Transfer Case (Service Information)): Clutch: Disassembly: Disassembly

2014 Jeep Grand Cherokee Laredo, AWDSECTION Disassembly
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Clutch Components
GC0146337Courtesy of CHRYSLER GROUP, LLC
1 - MAINSHAFT
2 - DRIVE SPROCKET
3 - CLUTCH HOUSING
4 - CLUTCH HOUSING RETAINING RING
5 - SPROCKET SPACER T-WASHER
6 - CLUTCH HUB
7 - FRICTION PLATE
8 - STEEL REACTION PLATE
9 - CLUTCH SPRING
10 - CLUTCH PISTON
11 - THRUST WASHER
12 - THRUST BEARING
13 - BALL RAMP A LEVER
14 - BALL
15 - LEVER B ASSEMBLY
16 - THRUST BEARING
17 - THRUST WASHER
18 - THRUST COLLAR
19 - CLUTCH SHIM
20 - RETAINING RING
NOTE:

If the transfer case assembly is being reconditioned (clutch/seal replacement) or replaced, it is necessary to perform the Quick Learn Procedure using the Scan Tool.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.