Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (8HP70 AUTOMATIC TRANSMISSION (SERVICE INFORMATION))STANDARD PROCEDUREC-CLUTCH MEASUREMENT
2014 Jeep Grand Cherokee Laredo, AWD
C-Clutch Measurement
2014 Jeep Grand Cherokee Laredo, AWDSECTION C-Clutch Measurement
WARNING: This page is about a different variant/trim than selected.
- Using (special tool #8901A, Pressing Tool) (2) and (special tool #10429, Gauge, Force) (1) place the C-clutch (3) in a suitable arbor press (with the backing plate facing up).
- Apply 200 N (45 lbs.) of force to the C-clutch to compress the wave plate.
- With a suitable feeler gauge, measure the gap between the C-clutch backing plate and the C-clutch retainer.
- Refer to clutch clearance table for specifications. If clearance is not within specification a thinner or thicker selectable backing plate can be installed to achieve proper clearance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.