Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 29 (6.4L - DTCS P000B TO P0300)DIAGNOSIS AND TESTINGP0222-THROTTLE POSITION SENSOR 2 CIRCUIT LOWSET CONDITION
2014 Jeep Grand Cherokee Laredo, AWD
Set Condition
2014 Jeep Grand Cherokee Laredo, AWDSECTION Set Condition
WARNING: This page is about a different variant/trim than selected.
Throttle Position Sensor voltage at the Powertrain Control Module (PCM) is less than 0.16 volts for 0.7 seconds. One Trip Fault. Three good trips to turn off the MIL. ETC light will illuminate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.