Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 21 (3.0L DIESEL NAFTA - INTERMITTENT DTC, PCM/ECM/TCM PROGRAMMING, PCM VERIFICATION TEST & PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE)STANDARD PROCEDUREPCM/ECM/TCM PROGRAMMINGREPAIR PROCEDURE - WITECH™ DIAGNOSTIC APPLICATION
2014 Jeep Grand Cherokee Laredo, AWD
Repair Procedure - WITECH™ Diagnostic Application
2014 Jeep Grand Cherokee Laredo, AWDSECTION Repair Procedure - WITECH™ Diagnostic Application
WARNING: This page is about a different variant/trim than selected.
NOTE:
If this flash process is interrupted or aborted, the flash should be restarted.
- Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 Volts.
- Connect the wiTECH™ Vehicle Connection Interface (VCI) pod to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN" position.
- Launch the wiTECH™ Diagnostic Application and connect to the appropriate wiTECH™ device.
- From the wiTECH™ Diagnostic Application Home screen,
- Select "HELP"
- Select "HELP CONTENTS"
- Follow the "HELP TOPIC" for flashing an ECU.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.