Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL INJECTION, GASSENSOR, CRANKSHAFT POSITIONREMOVAL5.7L/6.4L
2014 Jeep Grand Cherokee Laredo, AWD
Sensor, Crankshaft Position: Removal: 5.7L/6.4L
2014 Jeep Grand Cherokee Laredo, AWDSECTION 5.7L/6.4L
The Crankshaft Position (CKP) sensor (4) is located at the right-rear side of the engine cylinder block (1). It is positioned and bolted into a machined hole in the engine block.
- Raise vehicle.
- Disconnect CKP electrical connector (2) at sensor.
- Remove CKP mounting bolt (3).
- Carefully twist sensor from cylinder block.
- Remove sensor from vehicle.
- Check condition of sensor o-ring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.