Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL INJECTION, GASSENSOR, CRANKSHAFT POSITIONREMOVAL3.6L
2014 Jeep Grand Cherokee Laredo, AWD
Sensor, Crankshaft Position: Removal: 3.6L
2014 Jeep Grand Cherokee Laredo, AWDSECTION 3.6L
The crankshaft position (CKP) sensor is mounted into the right rear side of the cylinder block.
- Disconnect and isolate the negative battery cable.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the front suspension skid plate. Refer to PLATE, SKID, FRONT SUSPENSION, REMOVAL .
- Push back the heatshield (1) from the crankshaft position (CKP) sensor.
- Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.
- Remove the sensor mounting bolt (2).
- Carefully twist the sensor (1) from the cylinder block.
- The CKP sensor O-ring (1) can be reused if not damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.