Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2014GRAND CHEROKEE LAREDO, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, BODY CONTROLREMOVALREMOVAL
2014 Jeep Grand Cherokee Laredo, AWD
Module, Body Control: Removal: Removal
2014 Jeep Grand Cherokee Laredo, AWDSECTION Removal
- Disconnect the negative the negative battery cable
- Remove the passenger side lower dash closeout panel.
- Remove the passenger side lower kick panel. Refer to PANEL, COWL TRIM, SIDE, REMOVAL .
- Disconnect all of the Body Control Module (BCM) connectors.
- Remove the two lower fasteners (2) securing the BCM to the bracket.
- Slide the BCM down until the BCM is released from the two interference tabs located at the top of the BCM.
- Remove the BCM (1) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.