Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE
(Steering Control Module (SCM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- C1219-Steering Angle Sensor Erratic Performance
- C121A-Steering Angle Sensor Not Initialized
- C123F-Steering Angle Sensor Comparative Performance
- C1240-Steering Angle Sensor Angle OVERTRAVEL Performance
- C1241-Steering Angle Sensor Velocity Performance
- C2102-System Voltage Low
- C2103-System Voltage High
- C2205-Steering Angle Sensor Internal
- U0001-Can C Bus
- U0121-Lost Communication With Abs
- U0141-Lost Communication With IPM (FCM/TIPM)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.