Diagnostic Test

2013 Jeep Wrangler Sport, Standard TransSECTION Diagnostic Test
  1. CHECK IF COMMUNICATION RELATED DTCs ARE PRESENT 
    1. Turn the ignition on.
    2. With the scan tool, read ABS DTCs.

      Are any Communication related DTCs present?

      Yes 

      No 

      • Go To  2
  2. CHECK IF OTHER STEERING ANGLE SENSOR RELATED DTCs ARE PRESENT 
    1. With the scan tool, read ABS DTCs.

      Are any other STEERING ANGLE SENSOR DTCs present?

      Yes 

      No 

      • Replace the Clockspring in accordance with the Service Information.
      • Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.