Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2013WRANGLER SPORT, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 256 ((TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS))DTC TROUBLESHOOTINGU0114-LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULEWHEN MONITORED
2013 Jeep Wrangler Sport, Automatic Trans
When Monitored
2013 Jeep Wrangler Sport, Automatic TransSECTION When Monitored
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Continuously when the ignition is on.
Battery Voltage between 10 and 16 Volts.
Ignition Off Draw (IOD) fuse installed.
Body Control Module (BCM) is configured correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.