Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2013WRANGLER SPORT, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 161 (DTC INDEX)MODULE, INTRUSION TRANSCEIVER (ITM)
2013 Jeep Wrangler Sport, Automatic Trans
Module, Intrusion Transceiver (ITM)
2013 Jeep Wrangler Sport, Automatic TransSECTION Module, Intrusion Transceiver (ITM)
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1A20-00 | PRE-ARM TIMEOUT |
| B1A3C-00 | INTERNAL SIREN BATTERY |
| B1A3D-00 | SIREN BATTERY TAMPER/LOSS OF POWER SUPPLY |
| B1A3E-00 | SIREN/ITM MISMATCH |
| B1A3F-00 | ITM ARMING SEQUENCE PERFORMANCE |
| B1A88-92 | ULTRASONIC SENSOR CIRCUIT - PERFORMANCE OR INCORRECT OPERATION |
| B210A-84 | SYSTEM VOLTAGE LOW - SIGNAL BELOW ALLOWABLE RANGE |
| B210B-85 | SYSTEM VOLTAGE LOW - SIGNAL ABOVE ALLOWABLE RANGE |
| B2206-00 | CURRENT VIN MISSING/MISMATCH |
| B222A-00 | VEHICLE LINE MISMATCH |
| B223C-00 | INTRUSION TRANSCEIVER MODULE INTERNAL |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER/CCN |
| U110D-00 | LOST COMMUNICATION WITH SECURITY SIREN |
| U140E-00 | IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED |
| U1415-00 | IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA |
| U1416-00 | IMPLAUSIBLE SECURITY SIREN SIGNAL RECEIVED |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.