SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER V6-3.8LREPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORSERVICE AND REPAIRGENERATOR - INSTALLATION
2011 Jeep Wrangler V6-3.8L

Generator - Installation

2011 Jeep Wrangler V6-3.8LSECTION Generator - Installation





INSTALLATION





1. Install generator mounting fasteners (1), (2), and (3) and tighten. Refer to Torque Specifications.

CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to Belt Schematics in Cooling System.

2. Install generator drive belt. Refer to Cooling System for procedure.





3. Snap field wire connector (2) into generator.
4. Install B+ terminal to generator mounting stud. Tighten mounting nut. Refer to Torque Specifications.
5. Snap plastic cover (1) to B+ terminal.
6. Install negative battery cable to battery.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.