Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER V6-3.8LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRHEATED SEAT MODULE - REMOVAL
2011 Jeep Wrangler V6-3.8L
Heated Seat Module - Removal
2011 Jeep Wrangler V6-3.8LSECTION Heated Seat Module - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in possible serious or fatal injury.
CAUTION: Use care when removing the Heated Seat Module (HSM) from the seat to prevent damage to the plastic HSM housing and retainer. Failure to follow these instructions may result in damage to the HSM and retainer.
1. Disconnect and isolate the negative battery cable.
2. Remove the radio Radio - Removal.
3. Using an appropriate door trim tool or needle nose pliers, disengage the tab and push-pin retainer that secures the Heated Seat Module (HSM) (1) to the instrument panel support (2).
4. Disconnect the wire harness connector (3) from the HSM.
5. Remove the HSM from the instrument panel.
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.