Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Valve, Washer: Description: Rear
The rear check valve (2) is located in the hardtop disconnect plate (1) located in the left inner D-pillar (3) of the removable hardtop. The disconnect plate provides a washer plumbing interconnect between the rear washer hose (4) contained within the body wire harness and the hardtop washer hose connected to the rear wiper motor. The disconnect plate also provides an electrical interconnect between the body wire harness and the hardtop wiring connected to the rear wiper motor.
The check valve consists of a molded white plastic valve body with a raised center flange and two raised wedge locks that secure the unit in the disconnect plate. A barbed outlet hose nipple is formed on the side of the valve body oriented toward the rear washer nozzle, and a straight inlet hose nipple is formed on the side of the valve body oriented toward the washer pump. Within the check valve body, a small check ball is held against an integral valve seat by a small coiled spring.
The rear check valve cannot be adjusted or repaired and, if ineffective or damaged, it must be replaced.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.