Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER RUBICON, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE COOLING SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2011 Jeep Wrangler Rubicon, Standard
Torque Specifications
2011 Jeep Wrangler Rubicon, StandardSECTION Torque Specifications
WARNING: This page is about a different variant/trim than selected.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Bolt, Block Heater | 2 | - | 17 |
| Bolts, Condenser to Radiator | 8 | 18 | 71 |
| Bolts, EGR Cooler | 15 | - | 133 |
| Nuts, EGR Cooler Manifold | 25 | 18 | - |
| Bolt, EGR Cooler Manifold Elbow | 11 | - | 97 |
| Bolts, EGR Cooler Manifold Support Bracket | 45 | 33 | - |
| Bolts, EGR Cooler Support Bracket | 25 | 18 | - |
| Electric Fan to Fan Shroud Bolts | 6 | - | 53 |
| Bolts, Fan Blade Assembly to Viscous Drive - Diesel | 23 | 17 | - |
| Viscous Fan Drive - Diesel | 50 | 37 | - |
| Bolts, Fan Shroud to Radiator Mounting | 8 | - | 71 |
| Bolts, Radiator Upper Isolator to Crossmember | 9 | - | 80 |
| Bolts, Thermostat Housing - M6 | 12 | - | 105 |
| Accessory Drive Belt Tensioner Bolt | 45 | 33 | - |
| Idler Pulley Bolt | 45 | 33 | - |
| Bolts, Water Pump | |||
| 3.8L | 12 | 9 | 106 |
| 2.8L | 32 | 24 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.